Successor model of pinhole detector P100.
It provides brandnew HMI & maintenance functions.
Hole Detector TOSPECTOR-P100A Series
- As a detection sensor, a photo-multiplier is adopted and minimum 15μm or more hole is detectable.
- A general-purpose sequence controller is adopted as a signal processing system, it increases maintainability.
- An attached computer performs calibration and displays of various status. It is connectable and operatable to both equipment cabinet and a detection unit.
This table can be scrolled horizontally.
|Width||400 ～ 1300mm (located evenly to the line center)|
|Thickness||0.1 ～ 1mm|
|Detection sensitivity||15μm (Vertical hole, thickness is less than 0.15mm)|
|Shutter overlap||Adjustable within the range of 1 ～ 10 mm from the edge of the strip.|
|Pass line gap||In the direction of strip thickness, 4mm.|
|Pass line Fluctuation||±0.5mm or less of strip|
|Shutter driving||Automatic follow-up by electric servomechanism.
Response frequency 8Hz, One side swing, 5mm.
- * The specification shown above is an example. Actual specifications can be adjusted and may vary depending on installation conditions.